Vol. 4 No. 4 (2009): December 2009

Published: 2022-02-15

Articles

WEIBULL ANALYSIS OF HIGH CYCLE FATIGUE INVESTIGATIONS OF CAST MAGNESIUM ALLOY UNDER TRANSVERSE LOAD

Murugan G, Raghukandan K, Pillai U T C

218-222
- PDF
EFFECT OF FRICTION ON BARRELLING AND COLD WORKABILITY LIMITS OF AL-4%COPPER ALLOY DURING COLD UPSET FORGING AND FEA MODELING

Babu Rao J , Syed Kamaluddin, Appa Rao J, Sarcar M M M, Bhargava N R M R

223-232
- PDF
EXPERIMENTAL INVESTIGATION AND FAULT DIAGNOSIS OF A BOILER FEED PUMP UNIT

Raghu Kumar B, Ramana K V, Mallikharjuna Rao K

233-238
- PDF
MECHANICAL PROPERTIES OF FRICTION WELDED 6063 ALUMINIUM ALLOY AND MARTENSITIC STAINLESS STEEL

Sammaiah P, Tagore2 G R N

239-244
- PDF
EFFECT OF FLUSHING CONDITIONS ON MATERIAL REMOVAL RATE IN EDM

Navdeep Malhotra, Hari Singh

245-249
- PDF
DEVELOPING EMPIRICAL RELATIONSHIPS TO PREDICT TENSILE, IMPACT AND FATIGUE STRENGTH OF GTA WELDED AA 6061 ALUMINIUM ALLOY INCORPORATING PULSED CURRENT PARAMETERS

Senthil Kumar T, Balasubramanian V

250-256
- PDF
WAVELET DE-NOISING USING CUSTOMIZED THRESHOLDING FOR BEARING FAULT DETECTION

Patil M S, Jose Mathew, RajendraKumar P K

257-263
- PDF
DEVELOPMENT AND EVALUATION OF DENSIFICATION MODELS FOR Al-Pb ALLOYS PRODUCED BY POWDER METALLURGY

Ch V S H S R, Ranga Janardhana G

264-273
- PDF
APPLICATION OF MAINTENANCE PLANNING AND CONTROL FOR MANUFACTURING INDUSTRY: A CASE STUDY

Rupinder Singh , N S Bhangu, Sanjeev Kumar

274-282
- PDF
TEXTURAL ANALYSIS OF SHAPED SURFACES USING MACHINE VISION SYSTEM BASED AMPLITUDE PARAMETERS TO ESTIMATE THE CUTTING TOOL CONDITION

Prasad B S, Sarcar M M M

283-292
- PDF
SIMULATION IN MEMS OF THE STATUS OF SPECIFIC GRAVITY OF URINE AND ITS CORRELATION IN DATA MINING

Basak T K, T Ramanujam, Arpita Gupta, Poonam Goyal

293-297
- PDF