OPTIMIZATION OF PROCESS PARAMETERS IN ROLLING OPERATION FOR MANUFACTURING OF THERMOMECHANICALLY TREATED BAR USING MINITAB AND MATLAB SOFTWARE

Authors

  • Satish kumar sao sao BIT Durg

DOI:

https://doi.org/10.37255/jme.v17i1pp020-024

Keywords:

Yield Strength, TMT, Control Parameters, S/N Ratio, Taguchi Method

Abstract

At low cost, designing high-quality products and process is a challenge to the engineers. For the manufacturing of TMT bars, the critical quality parameter is yield strength. This study aims to choose the optimal variables that will achieve the needed yield strength. In this research work, the use of the Taguchi Method and the concept of DOE (Design of experiment) for optimization of Thermo Mechanical Treatment Process parameter. In the plant, readings have been taken by Taguchi Method and by using MINITAB and MATLAB Software to find optimal combination factors. For optimizing the process parameters ANOVA, S/N ratio (Signal to noise ratio), and orthogonal array have been utilized. Optimum values have been obtained with the help of graphs as well as a confirmation experiment.

Downloads

Download data is not yet available.

References

B. Vijaya Prakash (2019) selection of effective control factors for TMT Bars using Taguchi, International Journal of Engineering and Advanced Technology: 1458 - 1463

D. Ravi Kumar (2015) optimization of TMT Process by Taguchi Methodology, Journal of Material Science and. Mechanical Engineering, vol. 2 :44 - 47

Vivek anil Vaidya (2015) Application of Taguchi method for optimization of process parameters, International Refereed Journal of Engineering and Science, vol. 16:15 – 22

Peter U. Nwachukwu, oluleke O. and Oluwole (2017) effect of rolling process parameters on the mechanical properties of hot – rolled St60Mn steel Case Studies in Construction Materials, Vol. 6: 134-146

Min. Jiang. Li-Na Chen, Jin He. Gauang and Yao Chen (2014) effect of controlled rolling / controlled cooling parameters on microstructure and mechanical properties of the novel pipeline steel, Advances in Manufacturing, vol. 2: 265–274

Le Van Long and Dinh Van Hien (2020) Impact of cold –rolling and heat treatment on mechanical properties of dual –phase treated low carbon steel, Advances in Materials Science and Engineering, 1-9

Yuta fukuda and masafumi noda (2017) Effect of reduction in this thickness and rolling condition on mechanical properties and microstructure of rolled Mg-8Al-1Zn-1Ca Alloy, Advances in Materials Science and Engineering,1- 9

I.Schindler and M.Janosec (2009) Effect of cold rolling and annealing on mechanical properties of HSLA steel” Archives of Materials Science and Engineering 36(1): 41- 47

Ross, P.J. (1989) Taguchi technique for Quality engineering, McGraw-Hill. New York.

Roy, Ranjit K., (2001) Design of Experiment Using Taguchi Approach, First Edition, John Wiley and Sons.

Shan liu and wenxia li (2019) Effect of rolling temperature on micro structure and mechanical properties of a Nb-Mo micro alloyed Medium Mn Steel, Materials Research 21

H. Palkowski and M. Soliman (2008) Effect of thermo mechanical processing parameters on bake hardening, 3rd International Conference on Thermo mechanical Processing of Steels

Downloads

Published

2022-03-01

Issue

Section

Articles

How to Cite

[1]
“OPTIMIZATION OF PROCESS PARAMETERS IN ROLLING OPERATION FOR MANUFACTURING OF THERMOMECHANICALLY TREATED BAR USING MINITAB AND MATLAB SOFTWARE”, JME, vol. 17, no. 1, pp. 020–024, Mar. 2022, doi: 10.37255/jme.v17i1pp020-024.

Similar Articles

1-10 of 406

You may also start an advanced similarity search for this article.